Parts List and Instructions for K-Pro Installation in 2000-2005 Honda S2000

The following items must be replaced before the S2000 K-Pro can be used. These parts are not supplied by Hondata and should be purchased from a Honda dealer.

 -Crank sensor 37500-PZX-003
 -Crank wheel 13622-PCX-013
 -TDC sensor 37510-PZX-003
 -TDC wheel 14112-PCX-003
 -Valve cover 12310-PCX-020
 -Drain plug washer (for PCV valve) 94109-14000
 -PCV valve 17130-PCX-003
 -IAT sensor 37880-P05-A00 (not required, but stock IAT will read about 30 degrees hotter). Swapping the parts is relatively straight forward. Refer to the Helm manual for more information, but in brief you will need to:

 -Remove the accessory belt.
 -Remove the water pump pulley.
 -Remove the crank pulley.
 -Remove the front timing cover.
 -Remove and replace the crank timing wheel.
 -Remove and replace the crank sensor in the timing cover, and reinstall the timing cover.
 -Remove old wiring to crank sensor.
 -Install wiring harness from crank sensor to ECU.
 -Reinstall water pump pulley and accessory belt.
 -Remove the valve cover.
 -Remove and replace the TDC sensor wheel (exhaust cam).
 -Install the new TDC sensor and PCV valve in the new timing cover, and install the new valve cover.
 -Remove S2000 ECU. Install the wiring harness through the firewall underneath the clutch master cylinder.
 
If you have cut the wiring rubber boot, seal it with silicone sealer.
 -Install the ECU.

Loading...